Why is there a bulge problem in the repair paint of Qingyuan Automobile
1、 Reason: The air trapped under the paint film expands, causing the paint film to separate from the substrate.
a. Improper application methods for atomic ash, eye filling ash, or primer, resulting in air trapping in the paint film.
b. Improper treatment of feather edges at the junction of the paint film.
c. The paint film covers the gaps or dead corners, creating gaps underneath the paint film.
d. The use of poor quality diluents or inadequate diluents, high compressed air pressure, or dry spraying can create pores or bubbles inside the primer.
e. Failure to properly handle and close the substrate, especially when spraying the exterior of fiberglass.
f. The temperature is too high when drying the paint film.
2、 Prevention:
a. Properly apply atomic ash, eye filler, or primer.
b. Properly make feather edges.
c. Avoid spraying paint too thick at once, ensuring that the paint penetrates into gaps and dead corners.
d. Be sure to use the recommended thinner and operate according to the correct spraying process. The primer should be sprayed thin and wet.
e. Check if there are any air holes on the substrate, and pay special attention to the bubbles inside the outer adhesive layer of the fiberglass. Carefully remove bubbles and close the substrate.
f. When baking the paint film, avoid excessive temperature.
3、 Repair:
Grind off all the corresponding paint film according to the depth of the bubbles, repair the defects in the base layer, and then spray the paint again.
Article source: Qingyuan Automotive Repair Paint http://www.jinliangxincai.com
-
08-25
Common problems with automotive repair paint
Why are the orange lines on the surface of the varnish so heavy after each spray? Why on earth? How can we prevent a decrease?Answer: The thinness of the varnish, the amount of paint produced by the s
-
06-05
The car repair paint manufacturer told you about the problem with water-based coatings
1. How long does it take for a skilled paint coating technician to master the operation of water paint?Generally, practice and understanding with less than half a sound can be mastered, and proficienc
-
05-31
Qingyuan Automobile Repair Paint Company tells you the steps for painting
Automotive Painting Process(1) Rust prevention and internal painting of the vehicle body: Depending on the condition of the vehicle body, it will be completed by a sheet metal worker.(2) Polishing and
-
05-12
Why does car repair paint lack luster?
If there is a lack of gloss on the surface of the originally flat and smooth car paint surface, especially during the process of car paint care, it can be observed under a microscope that the surface